Hazards and Cautions

• Clean before first and each use.
• Before first use place all components separately in boiling water for 5 minutes. This is to ensure hygiene.
• Check all components before each use and throw away at the first signs of damage or weakness.
• To ensure proper cleaning/sterilising all bottle parts MUST be disassembled.
• Cleaning/sterilising while assembled can damage the bottle.
• Dishwasher safe on top dishwasher rack (max. 65c) but food colourings may discolour components.
• Do not use abrasive cleaning agents. Only soft bristle brushes or soft sponges should be used. Hard scourers may scratch the plastic.
• Sterilise using one of the following methods: steam sterilising (electric or microwave according to manufacturer’s instructions), boiling in water for at least 5 minutes or liquid sterilising solution.
• Do not leave single bottle parts in direct sunlight or heat, or leave in sterilising solution for longer than recommended, as this may affect proper function.
• The bottle is made of polypropylene which is hygienic, easy to clean and relatively soft. Avoid heavy pressure on it, as this could affect the function.
• Do not use pin or sharp object to enlarge feeding hole.
• Use sugar free food or liquids only
• When first used and sometimes for later usages, the slit in the ventilation (the raised, slit bubble on the underside of the teat base) can stick together, therefore not allowing air to enter the bottle during feeding and as a result, the teat collapsing. Slowly brush the bubble (ventilation) a few times with your thumb or fingers to re-open the slit.
• To avoid injury, do not let baby walk with bottle. Prolonged contact with liquids may cause severe tooth decay
• Insert teat into top of bottle screw ring until you hear a “click”